A distinctive Toshiba failure is a distinctive whining sound which can be heard just before the drive stops working. It is also common to hear the sound of the motor attempt to spin up, fail, and then retry repeatedly. Toshiba drives can also suffer surface damage caused by the heads being exposed to excessive heat, the heads will begin to adhere to the disk's surface leading to scratches and the manifestation of bad-blocks.
I have a LaCie external hard drive, USB2. It has been working properly for like 6 months, either on a Mac or on my VAIO laptop.
On this VAIO, I reinstalled windows yesterday. Since then the external Hard Drive won't show in "my computer" or anywhere. I can see it in the "peripherials", it says it's working properly, no problem, I installed the drivers form www.lacie.com.
But I can only see the C:/ and the D:/ drives, no other one. I can't access to its content at all.
..D Glen, Newcastle upon Tyne, UK
Another issue typical for Toshiba hard drives is damage to the components on the PCB board. Toshiba Hard Drives are vunerable to overheating and power surges which can lead to a burned out motor or blowing a controller chip on the logic board. If the chips on the PCB burn out you would smell smoke in the air. On next boot your Toshiba hard disk will probably not even spin up. To recover from this type of problem we need to modify a new PCB board with rom information from original drive.The Toshiba drive can spin up and the head starts clicking right from the beginning with a regular clicking sound
. More times than not this a sign of bad heads, if this is the case it is very important to perform accurate diagnostics and eliminate a chance of possible firmware corruption or PCB failure that sometimes could also cause clicking.
The last typical Toshiba hard drive issue applies also to all other hard drive makes and models, the problem is called bad sectors. After some period of time the platters were the data is located starts to degrade and bad sectors appear.
I am having issues with my external drive. I removed hard drive from enclosure and connected it with another enclosure. In all cases there was no bad sounds from the hard drive. No spin-up, it was like the hard disk was dead. It seems like there is no power going to the hard drive, could this be electronic failure?
Paul Presley
Aberdeen
Whenever the hard drive attempts to read bad sectors it could start freezing, scratching, ticking and sometimes loud clicking. This leads to further damage to the surface and causes more data loss. As soon as you start experiencing such symptoms while reading important files, stop the drive immediately and consider sending it to a data recovery company like ourselves for a free diagnostic. Any further attempts to read the Toshiba drive would just add up to the problems and make more data unrecoverable. In our Data Recovery Lab we use expensive imaging tools that are capable of force reading bad sectors from Toshiba Hard Disks. This is usually the only way to effectively retrieve data from these Drives.
If you experience any of the symptoms described above with your Toshiba MK1926FBV HDD2527 815MB please call us on +44 (0) 2890 961976.
If you hear your Toshiba MK1926FBV HDD2527 815MB hard drive making some other unusual noises please call us on +44 (0) 2890 961976.
