 Data Recovery:
All Western Digital Hard Drive Recovery is Recession Price was €600 now only €249.99. If you have a vat number we do all our recovery jobs vat free. Save yourself 23% tax! We have also reduced all our data recovery prices as a current special offer. We currently offer the quickest data recovery service in Ireland. We currently have two offices, one in Belfast and another in London. We were the 1st data recovery company in Ireland to offer all our data recovery services on a 'No Fix No Fee' basis. We successfully recovery 99% of all hard drives we receive and in many cases, return the recovered data within 48 hours! Our No Fix No Fee policy means if we cannot recover your data then you pay nothing.
   
Your Western Digital Drive will produce error messages as below:
1.Clicking / Ticking / Scratching / Grinding Sounds
2.Primary Hard Disk not found
3.Not spinning, Not powering on at al
4. Invalid partition table entries
5.Drive not working after Power Surge
6.Primary/Secondary Hard disk failure
7.Freezing or locking up the computer or buring smell from system
8. Hard drive beeps repeatly
9.Not detected by computer's CMOS/BIOS
10.Water or Liquid spilled on Hard Disk
11.Hard drive is quiet, probably means motor is not spinning
12.Accidental reformatting of partitions, Accidental Deletion of Data, Virus Problems
13.Non system disk or disk errors
14.Hard disk is unable to be accessed ( Inaccessible drive or partition )
15.Unable to boot computer due to system getting dropped.
16.The disk is seen in Operating System but asking to be formatted
17.Front red light on system not displaying
18.Error reporting ' Primary Master disk failed, Press F1 to continue'
Follow the process below to send your hard disk or media to us:
Step 1
Post your Hard Disk to our postal address below. Send the Hard Disk via a suitable postage or courier service together with your Contact Details (Full Name, Postal Address, Email Address and Phone Number). We recommend Registered Post via the Post Office. The average costs are around €5.00 via this delivery method and will take one to two days to get delivered to us.
Our Address:
EasyRecovery
105 Upper Lisburn Road, Belfast, BT10 0LG
Step 2
We will perform a full diagnostics on the hard disk to confrim what the problem is with the disk and what the best solution is to recover the data. We will then contact you to give you the results and give you the recovery options that are available. We will also confirm price with you at this stage.
Step 3
Once you give the go-ahead for the recovery, we will run the recovery job to extract data. Once we complete the data recovery job we will present the results to you normally via email but also can be completed over the phone. Once you are 100% happy with the results we will back up your data to suitable media.
Step 4
Once we have backed up your data - normally to Data DVD or a portable hard disk we will send the data back to you via a courier service. The courier service is included in our standard prices. Our aim is to complete the whole data recovery process within 48 hours of receiving the hard disk.
Western Digital Data Recovery Information:
When it comes to data recovery one of the most common problems Western Digital hard disks experience is burnt board (PCB).Western Digital manufactures a large portion of the world's hard disk drives. In recent years the company has broken ground in the storage industry with a number of innovations. In 2001, a series of ATA hard disk drives (Special Edition) with an 8MB cache buffer were released at a time when most hard drives ran with only a maximum 2MB of buffer. Then, in 2003, they launched the world's first 10,000RPM Serial ATA hard disk drive, The Raptor, a 36 GB unit with an access time of less than 6ms - followed soon after by a quieter 74GB version. Western Digital drives are vulnerable to overheating. Bad power supply unit's combined with a power surge is usually enough to damage micro chips on the electronics PCB and make the data inaccessible.
If your drive suffers from an electronic failure then we can recover the data for you. In our data recovery lab we use specialised hardware systems to modify a new PCB electronic board and then use specialised software to rewite corrrect firmware modules to the hard drive. This Western Digital fix helps us recover a large precentage of these electronic damaged drives.
Western Digital drives have a tendency to sustain damage to the hard drive's firmware zone thus blocking access to the data on the hard disk. Typically, when the system is booting up, it will hang for a few seconds while the BIOS tries to find the volume. Even though the hard disk may or may not be recognised correctly (if at all) the drive's performance will slow dramatically before it the hard disk fails altogether, other failures include:
- It is not found in BIOS when you boot your computer.
- Identifies the hard drive as its factory alias (for example WDC ROM MODEL-HAWK)
- Shows up with wrong S/N (for example WDC-ROM SN# 254) or capacity,
- Identifies fine but fails to read any data or boot up operating system giving I/O device errors whenever you try to access the sectors on the hard drive.
If you attempt to boot up from such drive or read any data from it you would get "Primary Master Hard Disk Fail" or "No operating system found" or "S.M.A.R.T. Capable But Command Failed" or "Disk boot failure. Insert system disk and press enter", "Hard drive not recognized", "Drive Mount Failure" or some other hard drive boot error.
The Western Digital drive can spin up and the head starts clicking right from the beginning with a regular clicking sound . More times than not this a sign of bad heads, if this is the case it is very important to perform accurate diagnostics and eliminate a chance of possible firmware corruption or PCB failure that sometimes could also cause clicking.
AV-GP
Heads are normally parked on the parking ramp outside of the platters, but sometimes after a fall or abnormal termination they fail to return to their regular parking position and are left on the surface. Immediately after the motor stops spinning they stick to the ideally smooth surface and it becomes impossible to free them without proper tools and experience. Don't attempt to open the drive by yourself - you will damage the platters and this will make your data unrecoverable.
The last typical Western Digital hard drive issue applies also to all other hard drive makes and models, the problem is called bad sectors. After some period of time the platters were the data is located starts to degrade and bad sectors appear.
Whenever the hard drive attempts to read bad sectors it could start freezing, scratching, ticking and sometimes loud clicking. This leads to further damage to the surface and causes more data loss. As soon as you start experiencing such symptoms while reading important files, stop the drive immediately and consider sending it to a data recovery company like ourselves for a free diagnostic. Any further attempts to read the Western Digital drive would just add up to the problems and make more data unrecoverable. In our Data Recovery Lab we use expensive imaging tools that are capable of force reading bad sectors from Western Digital Hard Disks. This is usually the only way to effectively retrieve data from these Drives.
As always we are here to help and offer professional advice regarding data recovery. Our business hours are Monday - Friday 9am - 5.30pm. You can also email us at email addresses below if you require a quote via email. The more information you can provide us regarding the hard disk failure the more detailed quote we can provide you.
support@easyrecovery.ie
sales@easyrecovery.ie
|
